/Community

The code is not being displayed when i invoke prettycode interface from vb6 via addin.

Steps to Replicate It:

1. Open any project in VB6 with lot's of code, make sure the prettycode addin is loaded.
2. Open a class module or a form in code view.
3. Click the addin button (near save)
4. It will load all the forms/modules to the treeview.
5. By default a node get's selected in the TreeView(left side).
6. But the code for the selected node is not being displayed.


Is this a bug or is the design that way. If it works the way it is designed. Then i apologize for your time that you wasted on reading this. If not then i think it would be a good idea to get the code to be shown.

Btw it would also be a good idea to do a syntax coloring not just in the preview but also in texbox where you show the code.

Hi Vikram,

I have followed the steps you have detailed and get the same end result. However, the first node that is selected is the project itself which doesn't have code.

Am I misunderstanding your question?

Regards,

Stuart

IF a project is selected then the window should remain empty which is current in your case. In my case the default selection on the treeview was a from, who's code should have been displayed. I have sent a mail to support mail and wonkotsane's hotmail id with the screenshot, to make things more clearer.